Vxl-instruments Itona TC72yy Series Instrukcja Użytkownika

Itona TC72yy Service Manual

Replacing RAM 6 4 Replacing RAM To replace RAM: 1. Remove the power adapter and side cover . For more information see Removing the Side Cover on pa

7 Replacing RAM 4. Place the new RAM on the socket. Note: Ensure that the new RAM is of the same dimensions as the existing RAM. 5. Slide the RAM

Replacing Flash 8 5 Replacing Flash To replace Flash: 1. Remove the power adapter and side cover. For more information see Removing the Side Cove

9 Replacing Flash 4. Place the new flash in the socket and press it downwards. Note: Ensure that the new flash is of the same dimensions as the ear

Replacing the Motherboard 10 6 Replacing the Motherboard To replace the motherboard: 1. Remove the power adapter and side cover. For more informati

11 Replacing the Motherboard Figure 10: USB, VGA and COM port cables 4. Remove the motherboard as shown in Figure 11. Figure 11: Motherboard Scr

Replacing the Motherboard 12 Figure 12: Removing Motherboard 6. Replace the existing motherboard with a new motherboard. 7. Using the star screw

13 Removing the Power Supply Unit 7 Removing the Power Supply Unit To replace the power supply unit: 1. Disconnect the ATX power supply cable as sh

Removing the Power Supply Unit 14 Figure 15: Power Supply Unit 4. Remove the wires connected to the power supply unit. You may replace a new unit

Copyright © 2004-2012 VXL Instruments Limited. All Rights Reserved Information in this document is subject to change without notice and does not rep

Table of Contents 1 Tools Required 1 2 Thin Client Bracket 3 Removing the thin client from the bracket 3 3 Removing the Side Cover 4 Fixing

Warning and Caution Statements Warning: It is best to wear an electrostatic discharge (ESD) cuff when handling electronic components (Motherboard,

1 Tools Required 1 Tools Required The tools required for servicing the Itona TC72yy Thin Client are shown in Figure 1. Figure 1: Tools Required

Tools Required 2 B. Phillips screw driver C. Hex Nut driver 5.0 mm D. Nose pliers with spring

3 Thin Client Bracket 2 Thin Client Bracket Removing the thin client from the bracket The procedure to remove the thin client from the bracket is ex

Removing the Side Cover 4 3 Removing the Side Cover The procedure to remove the side cover of the client is explained in this section. To remove the

5 Removing the Side Cover 1. Gently press the side cover downwards. 2. Using the star screwdriver (Item B in Figure 1) tighten the two screws hold