Vxl-instruments Itona TC75yyd Series Instrukcja Użytkownika

Itona TC75yyd Service Manual

Replacing RAM 6 5. Slide the RAM into place until the clip snap-fits at each end of the SO-DIMM socket. Note: You will hear a distinctive click s

Replacing the Flash 7 5 Replacing the Flash 1. Remove the power cord and side cover as described on page 4. 2. Using the star screwdriver, remov

Replacing the Motherboard 8 6 Replacing the Motherboard 1. Remove the power cord and side cover as described on page 4. 2. Unplug the cables and

Replacing the Motherboard 9 3. Using the Phillips screwdriver remove the four screws holding the motherboard as shown in Figure 6-2. Figure 6-2:

Replacing the Motherboard 10 Figure 6-3: Removing Motherboard 5. Replace the existing motherboard with a new motherboard. 6. Using the star sc

Removing the Power Supply Unit 11 7 Removing the Power Supply Unit 1. Remove the power cord and side cover as described on page 4. 2. Press the

Removing the Power Supply Unit 12 Figure 7-5: AC Power Unit Screws 5. Remove the power supply unit as shown in Figure 7-6. Figure 7-6: Removing

Replacing the Speaker 13 8 Replacing the Speaker 1. Disconnect the speaker cable from the motherboard as shown in 2. Using the star screwdri

Copyright © 2004-2014 VXL Instruments Limited. All Rights Reserved Information in this document is subject to change without notice and does not rep

i Table of Contents 1 Tools Required 1 2 Removing the Thin Client Bracket 3 3 Removing the Side Cover 4 4 Replacing RAM 5 5 Replacing the

ii Warning and Caution Warning: It is best to wear an electrostatic discharge (ESD) cuff when handling electronic components (Motherboard, RAM an

Tools Required 1 1 Tools Required The tools required for servicing the Itona TC75yyd Thin Client are shown in Table 1-1. A. Hex Screwdriver 2.5 mm

Tools Required 2 Table 1-1: Tools Required E. E. Nose pliers F. Isopropyl Alcohol ((CH3)2 CHOH) G. Hot Glue Gun with Rod

Removing the Thin Client Bracket 3 2 Removing the Thin Client Bracket 1. Turn off the power supply to the client. 2. Remove all the cables conn

Removing the Side Cover 4 3 Removing the Side Cover 1. Using the Hex screwdriver, unscrew the two screws as shown in Figure 3-1. Figure

Replacing RAM 5 4 Replacing RAM 1. Remove the power cord and side cover as described on page 4. 2. Apply isopropyl alcohol on the glue holding t